, 2013). Our study covered a ten-fold greater area (2315 km2 vs. 207 km2) with much lower sampling density (0.05 wells/km2 vs. 8.3 wells/km2), so it is possible that not enough samples were obtained to discern the valley-methane relationship, but it is also possible that other factors are driving methane patterns in this particular region. Our second method for classifying topographic position, which relied on location in valley-fill aquifers, led to different grouping compared to the first method that used distance to streams as an indicator of topographic position. Since wells were only considered to be located

in valleys when they were in a mapped valley-fill aquifer, there were fewer (n = 29) valley wells compared to the 67 identified using the stream-based method. Despite the difference Ceritinib cost in groupings, overall results were similar. Statistical comparison GPCR Compound Library of methane concentration and δ13C-CH4 using the Mann–Whitney test revealed no significant difference (p = 0.72; p = 0.27) ( Fig. 4c and g) between the distributions of methane for water samples located in valleys (n = 29) compared to those taken at upslope locations (n = 84). These findings are different from those of the recent USGS study in south-central

NY (Heisig and Scott, 2013), in that they did observe a statistically significant difference in methane concentrations by topographic setting. However, it was specifically wells located in confined valley aquifers that had statistically higher methane concentrations; methane concentrations in unconfined valley aquifers were not significantly different than those from upland sites. Boxplots showing distributions of dissolved methane from wells finished in sand and gravel aquifers (n = 9) compared to those from wells finished in Devonian sedimentary rock (n = 76) indicated a distribution skewed toward higher methane concentrations in bedrock wells. However, statistical comparison of methane concentration

and δ13C-CH4 using the Mann–Whitney Selleck Paclitaxel test revealed no significant difference (p = 0.10; p = 0.73) ( Fig. 4d and h) between the distributions from wells finished in sand and gravel aquifers compared to those from wells finished in Upper Devonian sedimentary rocks. The remaining 28 wells were not included in this comparison because they did not have available information on water-well depth or unit in which the well was finished. Separating out the 76 bedrock wells according to the particular geologic formation in which they were finished (which included five shale-dominated formations), there were still no significant differences (Kruskal–Wallis p > 0.05) across methane concentration or δ13C-CH4 (Fig. S1).