Due to these characteristics, GaN nanostructures exhibit superior performance to conventional planar GaN. An optoelectronic device using GaN nanowires was demonstrated in [9]. Though these GaN nanostructures (nanotube, nanowire, and nanocolumn) are exhibiting promising properties, fabrication of

an electronic device based on them is complicated because the separation of nanostructures inhibits electric current from flowing among these nanostructures. In the case of a photo detector based on GaN nanowires, the detector was learn more fabricated on an individual nanowire [10]. Fabrication of an electronic device on an individual nanowire is highly difficult. Nanowalls are attractive buy Ion Channel Ligand Library due to their porous surface and material continuity along the lateral direction. Carbon [11, 12], ZnO [13, 14], and NiO [15] nanowalls have been investigated. Kesaria et al. reported the growth of a GaN selleck compound nanowall network on a sapphire substrate [16–18]. In these papers, transformation among the GaN nanowall network, GaN nanocolumn, and GaN film is observed by changing the growth condition. On one hand, the width of the GaN nanowall is in nanoscale and, in terms of property, is as good as a separated nanostructure [16]. On the other hand, unlike nanotubes and nanowires, the GaN nanowall network is continuous along

the lateral direction. Because of this characteristic, the GaN nanowall network is expected to be fabricated to nanodevices as easily as the GaN film. A gas sensor was fabricated on a ZnO nanowall network using the same technology as film device [19]. Especially, using Si substrate, Si-based micromachining as well as integrated circuit can be applied to an integrated sensor [20]. In this paper, GaN nanowall networks were grown on Si (111) substrate by molecular beam epitaxy (MBE). Growth of GaN on silicon makes it compatible with the most mature silicon-based semiconductor technology.

Characterization of the GaN nanowall was carried out. Adjustment of the nanowall width ranging from 30 to 200 nm is achieved C-X-C chemokine receptor type 7 (CXCR-7) by adjusting the N/Ga ratio. Hall mobility and carrier concentration of the Si-doped GaN nanowall network were measured using Hall measurement system. Methods The GaN nanowall network was deposited on Si (111) substrate using a Riber 32 MBE system equipped with a N2 RF plasma source (RFS-N/TH, Veeco Instruments Inc., Plainview, NY, USA). The base pressure of the growth chamber is 3.0 × 10−10 Torr. The purity of N2, Ga, and Al is 99.9999%. A 380-μm-thick Si (111) substrate with a resistivity larger than 5,000 Ω·cm was cleaned in alcohol, followed by standard RCA process. Then, it was dipped in HF:H2O = 1:50 for a few seconds to remove the silicon oxide layer on the surface of the Si substrate as well as to form a hydrogen-terminated surface.