During the rotational GLAD process, the lateral component of deposition flux with respect to the surface Poziotinib purchase normal of the substrate contributes to the formation of columnar structures due to the shadowing effect, while the rotation of the substrate eliminates the preferred orientation growth, thus controls the shape of the structures. In the past few decades, there is considerable effort of both experimental investigation and atomistic simulations taken to investigate the fundamental mechanisms of the rotational GLAD [7–11]. Since nucleated islands acting as shadowing centers are essentially required for the formation of columnar structures in the initial period of the rotational

GLAD, recently placing nano-sized templates on the bare substrate is proposed to replace the nucleated AZD3965 islands, in such a way both deposition period and deposition

flux can be reduced significantly. Most importantly, by designing the geometry and the alignment of the templates, ordered arrays of columnar structures with pre-designed https://www.selleckchem.com/products/ulixertinib-bvd-523-vrt752271.html shapes can be fabricated under the intensified shadowing effect [12, 13]. Although the template-assisted rotational GLAD has been demonstrated to be one promising nanostructuring technique for the fabrication of 1D nanostructures, our fundamental understanding of the deposition process, particularly the deposition-induced deformation of the templates, is still limited: will the templates deform during the deposition? If yes, what are the underlying

deformation mechanisms of the templates? And how does the deformation behavior of the templates influence the geometry of the fabricated columnar structures? In this letter, we address the above questions by performing three-dimensional molecular dynamics (MD) simulations of the template-assisted Phosphoprotein phosphatase rotational GLAD of 1D Al columnar structures on Cu substrate. Our simulations demonstrate that the presence of templates significantly intensifies the shadowing effect to form 1D columnar structures when deposition flux is small, as compared to the template-free rotational GLAD. Furthermore, the morphology of the fabricated columnar structures by the template-assisted rotational GLAD strongly depends on the deformation behaviors of the templates. Methods Figure 1a illustrates the MD model of the template-assisted rotational GLAD utilized in the present work. The Cu substrate has a dimension of 11.6, 11.6, and 0.7 nm in X, Y, and Z directions, respectively. Periodic boundary condition (PBC) is imposed in the transverse X and Y directions of the substrate to simulate an infinitely wide thin film. There are nine equally spaced Cu templates of square cylinder placed on the substrate. The lattice constant a for Cu is 0.3615 nm. The width d for each template is 6a, and the distance s between each template is 10a. To investigate the influence of the template height h on the deposition process, two height values of 8a and 14a are considered.