However, in this type of sensor, the change of refractive index caused ARN-509 by the polymer upon conformational switching is usually too small to induce a color change of the pSi film that is detectable without the aid of a spectrometer [16]. Here, we develop pSi-based photonic sensors to detect changes in pH. The originality of this sensor is to use a pH-responsive polymer plug that acts as a barrier to prevent the water from penetrating into the porous matrix at neutral pH. As the pH decreases, the polymer becomes hydrophilic, thus opening up the pores of the porous layer and enabling water penetration. The water penetration results in a conspicuous

wavelength shift of the pSi reflector’s resonance, producing an optical signal visible to the unaided eye (Additional file 1). Methods Materials 2-Diethylaminoethyl acrylate (DEAEA) was obtained from Aldrich (Castle Hill NSW, Australia). The inhibitor was removed from DEAEA by passing the monomer two times over an inhibitor removal column from Sigma (Castle Hill NSW, Australia). 2,2′-Azobisisobutyronitrile selleck compound (AIBN; Aldrich) was recrystallised from ethanol. 2-Propanoic acid butyl trithiocarbonate (PABTC) was supplied by Dulux (Rocklea, Australia).

Toluene and tetrahydrofuran (THF; Aldrich) were of AR grade and were used as received. Synthesis PD184352 (CI-1040) of DEAEA polymer PABTC (0.037 g, 0.155 mmol) was placed in a round bottom flask and AIBN (0.0051 g, 0.031 mmol) was added to it. To this mixture, DEAEA (4 g, 23.359 mmol)

and toluene (1.33 g, 14.433 mmol) were added. The solution was homogenized by shaking at 0°C and deoxygenated by bubbling nitrogen through it for 20 min. The solution was placed in an oil bath at 65°C and polymerized for 24 h. After polymerization, the residual monomer and solvent was removed by precipitating the polymer in acetone. The polymer was dried under vacuum overnight. Monomer conversion was calculated by 1H nuclear magnetic resonance (NMR), performed on a 200-MHz Bruker spectrometer (Bruker Daltonics, Victoria, Australia). Molecular weights and molecular weight distributions were determined by gel permeation chromatographic (GPC) analysis using tetrahydrofuran as an eluent (40°C, 1.0 mL/min). The instrument was previously calibrated with polystyrene standards (Polymer Laboratories, Church Stretton, UK) with molecular weights ranging from 580 to 7,500,000 g/mol. Photonic pSi film preparation pSi films were prepared from single-crystal p-type silicon (boron doped, 0.0005 to 0.0011 ohm cm resistivity, <100 > selleck chemicals llc orientation) at a modulated current density with a sine wave (between 11.36 and 28.4 mA/cm2, 21 s periodicity) for 477 s in a 1:1 (48%) aqueous hydrofluoric acid ethanol solution, to produce a rugate filter.