In Figure 3b, a very small portion of the AFM tip presents a lattice darker than the rest of the Si tip. The tip curvature in this area is greater than that in the new tip. We can deduce from this that Si atoms at the tip surface underwent reflow under the electric field. Barasertib At the same time, the Au-NP melted, evaporated, and formed a compound with the Si at the tip apex.
The dark lattice area is estimated to be 1,000 Å2, which is very close to the circular ‘Au-atom-layer’ deposition area (1,145 Å2) predicted by the evaporation, electromigration, and deposition model. This case represents 44% of all the Au-NP attachment cases. Conclusions This study presents a novel AFM probe modification scheme in which a 1.8-nm Au-NP is applied by means of
a current-limited voltage pulse (2 ~ 5 V, ≥32 ns). TEM micrographs and fluorescence inspection results prove the existence of an Au-NP on the apex of the probe. An experiment involving the conjugation of single QDs also demonstrated the existence of a small amount of Au (equal to or less than 4 nm in diameter) deposited on the AFM tips, as well as the ability of the Au-modified AFM tip to pick up single macromolecules (QDs). We also discuss the mechanisms that may ITF2357 in vivo be involved in Au attachment: evaporation, electromigration, and deposition. The Au-NP was melted, evaporated, and deposited onto the tip apex by a sudden increase in the electric field due to a voltage pulse. The resulting AFM tips present an excellent platform for the manipulation of single protein molecules in the study of single protein-protein interactions. Acknowledgements This work was supported by grants from the National Science Council of Taiwan under the programs no. Procaspase activation 102-2627-M-007-002, no. 99-2120-M-007-009, no. 98-2120-M-007-001, no. 98-2627-M-007-002, and no. 98-2627-M-007-001. The authors thank the NTHU ESS C1GALT1 TEM Laboratory staff for their help and cooperation. We thank Dr. Tung Hsu at the Department of Material Science and Engineering, National Tsing Hua University, for the generous help with TEM. We also
thank Dr. Jin-Sheng Tsi from NSRRC for stimulating discussions and for designing the TEM sample holder. Electronic supplementary material Additional file 1: The file contains the method for the measurement of I , V , and R ; failed experiments; adhesion of an Au-NP to the probe apex during scanning; and experimental setup for fluorescence inspection. (DOCX 12 MB) References 1. Binnig G, Rohrer H, Gerber C, Weibel E: Surface studies by scanning tunneling microscopy. Phys Rev Lett 1982, 49:57–61.CrossRef 2. Binnig G, Quate CF, Gerber C: Atomic force microscope. Phys Rev Lett 1986, 56:930–933.CrossRef 3. Xie XN, Chung HJ, Sow CH, Wee ATS: Nanoscale materials patterning and engineering by atomic force microscopy nanolithography. Mater Sci Eng R 2006, 54:1–48.CrossRef 4.